Error 80070057 when attempting to update Windows Server 2012 R2

Once when I was updating some servers running the version of Windows Server 2012 R2 I encountered something odd; no patches appeared in Software Center or in the Windows Update panel, even though the server was several years out of date and definitely had applicable updates!

In WindowsUpdate.log I found the following error message repeating:


The fix for this is to manually download and install KB2919355, which is the April 2014 update rollup for Windows Server 2012 R2. After this has been installed and the server has restarted, re-run your updates scan and updates will show up in Windows Update or Software Center.

Increasing the maximum run time for Windows 10 and Windows Server 2016 cumulative updates

One of the things I have noticed since starting to deploy Windows Server 2016 is that the cumulative updates can fail to install when deployed from SCCM. It starts to run but then times out due to the maximum run time having been reached. By default this is set to 10 minutes. However due to the updates being larger and taking longer to install than updates prior to the cumulative updates era 10 minutes doesn’t seem to be long enough. The fix for this is to simply increase the maximum run time for cumulative updates for both Windows Server 2016 and Windows 10 from 10 minutes to 30 minutes.

Screen Shot 2017-06-05 at 23.12.35

Screen Shot 2017-06-05 at 23.12.47

This is a bit tedious as you’ll have to do it every month for both Windows Server 2016 and every version of Windows 10 you have in your environment. Hopefully Microsoft soon catches on to this and changes the default run time to 30 minutes so that this ceases to be an issue. There is already a Configuration Manager UserVoice entry for this idea, so if you’re reading this, pop over and vote to increase its visibility!

Automatically enable BitLocker and set a PIN during an SCCM Task Sequence

Getting your operating system deployment one step closer to being zero touch is always a good goal, so with that in mind here is how to automatically enable BitLocker during OSD using a PIN that you define in a variable at the beginning of the Task Sequence.

The first thing to do is add the OSDBitlockerPIN variable to the collection you advertise your OSD Task Sequences too. This is very likely the All Unknown Computers collection. Right click on it and select Properties. Navigate to the Collection Variable tab and click New. The name is OSDBitlockerPIN and you should untick “Do not display this value in the Configuration Manager console”.


Next up open your Task Sequence and add the Enable BitLocker step. This can be placed anywhere after the Setup Windows and ConfigMgr step.1 Make sure Current operating system drive is selected and then select TPM and PIN. You can then enter anything into this field as it will be overwritten by what you enter into the OSDBitlockerPIN variable when you start the Task Sequence.


Finally, go ahead boot your client into the WinPE environment. Select your Task Sequence and click next and you will be presented with the Edit Task Sequence Variables step. You may already use the OSDComputerName variable in which case you will already be familiar with this! Double click on OSDBitlockerPIN and enter the PIN you wish to use for this machine.


Click Next and the Task Sequence will run and complete. BitLocker will be enabled and the PIN will be set. Now you don’t have to configure BitLocker after the operating system has been deployed!

1I would add the Enable BitLocker step at the very end of your Task Sequence, otherwise you will have to enter the PIN each time the machine reboots after applications or updates are installed. You could suspend BitLocker before each reboot, but why go to the extra effort.